Canon IP4200, IP5200, Pro9000 cd printing instructions 
(16 votes, average: 3.5 out of 5)
Loading ...
April 29, 2007
22,838 Views
(16 votes, average: 3.5 out of 5) Loading ...Posted on April 29th, 2007 in IP Series, Pro Series by QuadCore ||
1. Remove plastic blocking the opening.
Remove the black plastic blocking the pathway.
2. Enable CD Print Feature:
I. Make sure the printer is off but is plugged in
II. Hold down [RESUME] (Triangle pointed down) and hold down [POWER] and wait 5 seconds or so.
Release [RESUME] but Continue to hold [POWER]. Double click [RESUME]. then Release [POWER].
Check to see you are in service mode by clicking [RESUME], than [POWER]. This should cause the printer to print a simple diagnostic that’ll list it’s ROM number and list CDR SENSOR=OK in red for the last line.
III. Click the [RESUME] 5 times then click [POWER] . This is the Destination setting option.
IV. Click the [RESUME] 4 times and then [POWER]. This is Europe, CD-R enabled.
Press [RESUME] then [POWER] again.
{{{ This will cause the same test with ROM information but this time: iP4200 EUR V1.04 {in cyan}
V. To confirm the new settings and return to printing mode press [POWER]. ß { Don’t forget otherwise it will default to JAPAN}.
3. Install the driver.
The USA driver will work just fine, it is on the CD that came with your printer. If the driver was already installed because you have been using the printer before you found this wonderful page, you will need to UNINSTALL it and RE-INSTALL it.
4. Install the CD-LabelPrint Software.
Download cd label print
5. Purchase a tray on eBay.
Search ebay for “Canon CD Tray”: http://search.ebay.com/
pingback:
